CONAPIDIL Superjection Home Full Spa Recovery Bundle

• Supports elasticity and firmness for a more lifted, resilient look
• Provides intensive hydration and helps prevent transepidermal water loss
• Helps maintain the appearance of professional post-procedure results
• Calms visible redness and sensitivity with Centella Asiatica, Guaiazulene & Allantoin
• Improves the appearance of dullness, fine lines, and uneven tone
• Provides a structured, step-by-step protocol for controlled at-home care

Kit Composition

• Starter (2 mL × 4 vials) – Hydrating prep ampoule
• Activator (3.5 mL × 4 vials) – Concentrated renewing ampoule
• Active Cream (18 g) – Barrier-supportive finishing cream
• Applicator L – Full-face rolling and absorption
• Applicator S – Precision application around eyes, lips, and localized concerns
  
  

PHASE 1 – PRE-TREATMENT PREP

5 × CemenSheet Masks

Use before Superjection Home sessions

• Soothes and hydrates the skin

• Reduces baseline redness and sensitivity

• Prepares the skin for improved absorption

• Supports a calmer response to active ingredients

• When to use:
  
  • 1–24 hours before Superjection Home treatment
  
  • Or immediately before on the same evening (followed by full drying)
  

**ONLINE COACHING INCLUDED WITH KIT**

Use in the evening, on clean skin. Recommended frequency:

• Typically 1–2 times per week, or as advised by your provider.
  
• For very sensitive skin, start with once every 1–2 weeks.
  

Step 1 – Starter (Prepping Ampoule)

1. Cleanse the skin thoroughly and pat dry.
   
2. Open one Starter vial and attach the hole cap.
   
3. Dispense an appropriate amount and apply evenly over the face.
   
4. Gently press with palms to enhance absorption.
   

Step 2 – Activator (Booster Ampoule)

1. Open the Activator vial and attach the hole cap.
   
2. Transfer contents into the Shooter device.
   
3. Attach Applicator L and gently roll over the face, avoiding direct contact with the eyes and lips.
   
4. Switch to Applicator S for more delicate or targeted areas (periorbital, perioral, or localized concerns).
   
5. Do not apply excessive pressure; allow the formula to glide over the skin.
   

Step 3 – Active Cream (Finishing Care)

1. Apply an adequate amount of Active Cream over the entire face.
   
2. Massage gently to lock in hydration and seal the active ingredients.
   
3. Optionally, you may layer a soothing mask on top of the cream for added calming.
   
   Do not place a mask directly on freshly treated or irritated skin without a cream buffer

5 × Cemenphlat Barrier Modeling Masks

Used after Superjection Home sessions

• Reinforces and restores the moisture barrier

• Calms irritation and redness

• Seals in actives and hydration

• Provides long-lasting moisture (24–48 hours)

When to use:

• 20–60 minutes AFTER Active Cream

• Or the following day if skin feels warm or sensitive